MANUALE ISTRUZIONI / INSTRUCTIONS MANUAL
MTR605/025/DASM - R605/027/DASM - R605/170/DASM
Modello/Model R605DASM
O/ 2
so
stituzio
ni_d
asm.fm
• Adjust play between motor- and intermediate-gear - see
A
DJUSTMENTS
• Tighten the two screws “
C
” - see
Figure 3
- chapter
A
DJUSTMENTS
• Connect the motor cable to the board.
• Re-mount the cover.
S
UBSTITUTION
OF
P
HOTOCELL
S
HUTTERS
.
• Remove the cover
• Unscrew the screws “
B
” and “
E
”- see
Fiuger 2 and 4
- chapter
A
DJUSTMENTS
• Disconnect cables from the board
• Substitute the photocell with an identical item.
• Connect the photocell cables to the board on connector J3V1 as follows:
Pin 1
not connected
Pin 2
not connected
Pin 3
black
Pin 4
red
Pin 5
white
Pin 6
green
• Mount the photocell supports
• Adjust photocell position - see
Figure 3
- chapter
A
DJUSTMENTS
• Re-mount the cover
Disassembly
• Disconnect supply to the collimator.
• Remove the rear cover and disconnect the supply cables.
• Loosen the 4 fixing Allen screws on the upper part of the collimator -
care must be
taken not to let the collimator fall.
Transport and storage
• Suitable packing must be provided for the collimator.
• Place the collimator in a plastic bag to avoid packing material from entering the col-
limator.
• Use an appropriate box for transport, shipment or storage taking care to protect the
collimator from rough handling. This will avoid damage to the collimator during
transport shipment or storage.
• Limit Storage conditions:
• Ambient Temperature = from -40°C to +70°C
• Relative Humidity = from 10% to 95%
• Atm. Pressure = from 500 a 1060 hPa
.
m
atori
\fig_
prec_trasp
o
