8
GB
START-UP
In this section you can learn how to set up the remote control for the
gas fireplace.
The remote control uses 2 x AAA 1.5V batteries.
Never use pointed tools to remove the batteries from the receiver
and remote control.
The signal range between the remote control and the gas fireplace
must not exceed 10 metres.
1. Press and hold the receiver’s “reset” button (see the red arrow)
until you hear a short ‘beep’ (A) followed by a long ‘beep’ (B).
2. After the second beep (B), release the reset button on the
receiver. You now have 20 seconds to press the “down arrow”
button (or minus icon on the PUCK) on the remote control.
3. Hold the button in, until you see the word “conn” on the remote
control. Then release the button.
The remote will then count to 8 and 2 short beeps (C) will sound
from the receiver.
The receiver and remote control are now synchronised, and the
fireplace can be lit.
NOTE!
Once a year you should replace the batteries
in the remote to ensure optimal operation.
Replace all the batteries at the same time and
use only good quality alkaline batteries.
REMOTE CONTROL
SYNCHRONISATION OF THE REMOTE CONTROL AND RECEIVER
SYNCHRONISE THE
REMOTE CONTROL
Scan the QR code to watch
a how-to-video
C
C
A
B
Receiver
Lines illustrate the duration
of the sounds
Remote
control
PUCK
REMOTE CONTROL