10
GB
USING THE REMOTE CONTROL
REMOTE CONTROL
HOW TO SWITCH ON THE FIRE
Press and hold the button to switch on the fire.
Be patient:
When you switch the fire on/off and use the remote
control, you must hold the button for a couple of seconds until the
ignition sign is displayed. Then release the button.
The main gas supply starts as soon as the pilot flame ignition is
confirmed.
It takes approximately 25-30 seconds for the fireplace to ignite.
The remote control will automatically enter manual mode - after the
main burner is lit.
HOW TO SWITCH OFF THE FIRE
Press and hold the button to switch off the fire.
Note:
The fire will not be able to be lit again until for 2-3 minutes.
FLAME HEIGHT ADJUSTMENT
1. To activate low heat, double press the button.
LO
is
displayed.
Note:
The flame will first switch to high heat before going to
low heat.
To get the absoulute minimum heat output, the secondary burners
should be turned off before activating low heat.
2. To activate high heat, double press the button.
HI
is displayed.
NOTE!
DEW AND CONDENSATION: The fireplace can form dew on the fireplace glass at start-up. When the glass is cold and
the appliance is lit, it may cause condensation and fog the glass. This condensation is normal and will disappear within
10-15 minutes as the glass and flue heats up.
Do not turn off the fireplace before all dew on the glass has gone!
If the fireplace is turned-off before the dew has gone, the water particles can damage the fireplace. Read more about
cleaning the glass under the “Service & Maintenance” section.
WARNING!
If the pilot flame does not light after 3 attempts, wait 3 minute before trying to light it again.
HOW TO SWITCH
THE FIRE ON
Scan the QR code to watch a
how-to-video
FLAME HEIGHT ADJUSTMENT
Scan the QR code to watch a
how-to-video
