ESP-LX Modular Controller
71
Attach the mounting template to the mounting surface at eye
level. Make sure that at least one of the mounting holes lines
up with a wall stud or other solid surface. Make sure the
template is level.
Drill or tap a pilot hole on each mark for the mounting holes.
Remove the mounting template from the surface. If necessary,
install wall anchors. Drive a #8 screw into the top center pilot
hole.
Slide the controller over the top center screw. Line up the
controller cabinet with the remaining four pilot holes. Drive
the appropriate fastener(s) through the mounting holes into the
mounting surface. Verify that the cabinet is secure.