SA 25
SA 25
SA 25
SA 25
SA 25
Chapter 3
Handling, installation, adjustments
© Raimondi S.p.a.
Via dei Tipografi, 11 - 41100 Modena (Italia)
Tel.: +39.059.280.888 - Fax: +39.059.282.808
www.raimondiutensili.it - e-mail: [email protected]
Use and Maintenance Manual
Page 21/44-3
3.4.3 Tank filling
TO CARRY OUT THIS OPERATION, MAKE SURE THE MACHINE IS NOT CONNECTED TO THE MAINS.
3.4.2 Assembly of the motor group
To assemble the motor group again perform the operations described for its disassembly in the reverse order.
THE LOCKING NUT SHALL NOT BE TIGHTENED COMPLETELY, BUT IT SHALL BE ADJUSTED SO THAT
THE CLEARANCE IS ELIMINATED, HOWEVER FREE MOVEMENT IS ALLOWED. BEFORE ASSEMBLE
THE MOTOR GROUP AGAIN, GREASE WELL THE PIN AND THE FACES COMING INTO CONTACT.
Min. 2 cm
After closing the drain hole with the specific plug, pour cold and clean water
into the tank until a level 2cm above the recycle pump has been reached.
Water level
Tank
Recycle
pump
