Railway Equipment 934, Operating Manual

Page: 23 / 62

P/N R9340-0104 23 © 2010 RAILWAY EQUIPMENT CO.
REV B
5/11
reset. To reset, turn knob.
2. KWH TOTAL
Display of accumulated KWH.
G. 1. RAIL TEMP __ F
Requires an optional rail temp sensor for display.
2. CABINET TEMP __ F
H. 1. HOUR METER
2. RESET HOUR
2. FAULT HISTORY:
The following FAULT COUNTERS will only be displayed if one or
more of the FAULTS of the type have been recorded. If a FAULT
COUNTER is cleared: it will no longer be displayed until another
FAULT occurrence.
A. PHASE 1 VOLTAGE FAULT COUNTER:
Phase 1 voltage low or high counter. To reset this fault, rotate
selector dial.
B.
PHASE 2 VOLTAGE FAULT COUNTER:
Phase 2 voltage low or high counter. To reset this fault, rotate
selector dial. Note this fault only applies to 3 phase models.
C. PHASE 3 VOLTAGE FAULT COUNTER:
Phase 3 voltage low or high counter. To reset this fault, rotate
selector dial. Note this fault only applies to 3 phase models.
D.
DAY COUNTER:
Day counter is the total number of days the EHAB control module
has been powered on.
E. POWER UP:
Power up counter is total count of power ups / processor resets.
To reset this value, rotate selector dial.
F.
OVERTEMP FAULT COUNTER:
Overtemp fault counter is total count of heat duct overtemps.
To reset this value, rotate selector dial.