2) Establish UDV (User Data Volume)
To establish 1 UDV, refer to the steps below:
a. Select “/ Volume config / User data volume”
b. Click and select “
“
c. First, enter a name for the UDV and then select a VG name and enter the capacity of UDV. Then
decide the capacity, block capacity, Read/Write and configure Priority. Finally click and select
“
”
d. The process is completed and a UDV has been established.
e. Repeat above steps to establish another UDV.
3) Add LUN for UDV
There are two ways of adding LUN to UDV
a. In “/ Volume config / User data volume”, click and select “
”
b. In “/ Volume config / Logical unit”, click and select “
”
The process is shown below:
c. Select a UDV
d. Enter “Host”, which is a name used to control the initiator for this block. Or enter wildcard “*”, which
means that each host can control this block. Configure LUN and permission and then click and select
“
”
e. The process is completed.
Hint: The rule for permission proceeds downwards.
4) Set shared hard disk
To configure the shared hard disk refer to the steps below:
Introduction to User Interface
37
