Raider RDP-TS11, User Manual

Page: 20 / 90

20 www.raider.bg
1. General information of machine
The Combined Mitre Saw and Bench Saw
(hereinafter - machine) designed for cutting wood,
aluminum and plastics (for special saw blade).
Operation in two modes:
● The mitre saw mode
● The bench saw mode
The transformation of the bench saw mode
to the mitre saw mode is produced by invert the
table quickly and without tools
Machine is designed to perform the following
operations:
In the mitre saw mode
• Cross-cutting at an angle;
• Bevel cuts ;
• Mitre cuts;
• Compound sawing (with bevel and mitre)
Sawing in the bench mode
• Lengthwise sawing;
• Lengthwise sawing with parallel fence
• Lengthwise sawing with an angle
• Cross-cutting
• Cross-cutting at an angle (with a bevel).
The power saw is set from single-phase AC
source with protective (grounding) wire. Electric
power source is in accordance with GOST 13109
-97, electric power source must be protected,
designated for 16A power input.
Machine is designed to work in following
conditions:
• The ambient air temperature is range from
plus 5 ° C to plus 40 ° C;
• Height above sea level to 1000 m;
• Relative humidity not exceeding 80% at +20
° C.
Execution as per water protection category –
no protection from water
Saw should connect the exhaust ventilation
system or exhaust device to remove chips and
dust. The minimum air flow is 20 m / s.
2. Safety instruction
Caution: Before you operation the machine,
please read the manual carefully. You must
comply with all requirements of this manual when
operating.
Forbidden:
• operate machine under the impact of drops
and sprays, as well as open areas during snow
or rain;
• To leave a saw attached to the mains, without
supervision;
• Transfer machine to a person who unable to
operate it;
• use machine for other purposes.
The machine should be off when a sudden
stops (in case a jamming of moving parts etc.).
During a pause, the switch must be covered.
To prevent the machine’s fuse automatic fuse,
the operation rated current is not less than 16 A.
Saw must be disconnected from the mains
power plug:
• When replace the tool, installing fixtures and
adjustment;
• When carrying machine from one location to
another;
• During a pause or after work is finished;
• For maintenance;
• When removing the sawdust
Never operate the machine in case of
occurence of one of the following faults:
• Damage of plug or electric cord;
• Damage to the grounding circuit;
• Occurrence of smell evidencing of isolation
burn or smoke;
• Improper work of automatic switch;
• The emergence of increased noise, the
rattle, vibration;
• Damage to or the appearance of cracks in
the body parts, a fence.
The cable must be protected from accidental
damage (it is recommended to hang it up). It is
forbidden to place the cable close range with dirty
and oily surface.
When working on the open areas, only a
designated and appropriately labeled extension
cable must be used.
Always make sure that there are no nails or
other things stuck in the treated materials.
Before switching on the machine put away the
spanners and adjustment tools to clear the work
space.
Do not wear very loose clothing and jewelry.
They can be captured by moving parts of the
machine. When working on an open area it is
recommended wear gloves and slip-resistant
footwear. Wear protective goggles and headgear.
For quality and safe operation, the cutting
portion of the working tools must be sharp and
clean. To replace the accessories comply with the
instructions. Keep the machine clean.
Additional security measures:
• Keep a clean work place;