28
www.raider.bg
main cutting edge, so Do not press workpiece into
saw blade. Rotational speed the blade should
remain constant. At the end of the cutting is
always Use the pusher 27. Pusher supplied.
• After cutting, off the machine (§ 6.5).
5.2.3 Lengthwise sawing with parallel fence
Emphasis parallel fence 57 has two levels of
working heights - 10 and 62 mm. The parallel
fence can be mounted on either side of the saw
blade. Installation of a parallel fence in the right
position, proceed as follows:
• Loosen the clamping nut58
• Push the support on the saw table to the left or
right side of the saw blade so that the clamp 60
come into contact with the back side edge of the
saw table.
• Put parallel guide57 on the support59, adjusting
the required level of working height stops. Tighten
the clamping nut 58. Make sure that the parallel
fence is parallel to the saw blade, If not, screwing
the screw 61 in or out to achieve parallelism.
Рic. 21.
57-Parallel fence; 58 -Clamping nut
59 - Support; 61 -Screw
• Tighten the clamping nut 58. The rear end portion
of the stop parallel fence should cover the length
of the nose of the riving knife. Wood between
the parallel fence and saw blade - it’s ready
manufactures, obtained from the workpiece.
• Use the profile to ripping low workpieces to allow
access between the blade and the parallel fence
for the push stick. The rear end of the parallel
fence should be level with the front of the riving
knife.
5.2.4 Bevel cut
• Loosen the clamping knob 37 tilt the cutting head
2 (Fig. 17).
• Set the blade to the desired angle of bevel scale
11 (Fig. 10)
• Proceed as the vertical lengthwise cut.
5.2.5 Cross-cut with bevel
The cross-cutting with the bevel should be use the
device for cross cutting at an angle 28 (supplied)
(Pic17, 22) Before operate, check the device to
match the starting point of 0 °.
• To adjust the device for cross cutting angle,
loosen the locknut 50 and tighten or loosen the
screw 51 until the pointer point to the angle 0 °.
• Set the angle of cutting.
• Slide bar 52 fit for cross cutting at an angle into
the groove B (Fig. 17), located on the left side of
the table.
• Loosen the thumbscrew 53 set the bevel angle,
to adjust the pointer to a required angle on the
scale.
• Tighten the bolt thumbscrew 53 installation angle
of the bevel.
• Hold the workpiece against the fence for
cutting at an angle. Turn on the machine and,
firmly holding the workpiece and move the
device along the slot with the workpiece. When
the cutting completed, turn off the machine
Pic 22
5.3 Changing from saw bench mode to miter saw
Proceed as:
• Remove the riving knife with guard 26 (Fig. 17);
• Remove the device for cross cutting at an angle
28;
• Set a maximum depth of cut (pra 7.2.1);
• Install and secure under-table guard in mode-
Compound miter saw (pra.7.1.1);
• Turn the table over (pra.6.2.2);
• Disconnect cutting depth adjustor 9, moving the
U-shaped bracket 47 from engagement with stop
48 (Fig. 18), and turn the adjustor upwards.
To perform these operations proceed as described
above.
Summary of Contents for RDP-TS11
Page 86: ...86 www raider bg ...
Page 89: ...89 ...
