24
www.raider.bg
Pic.10
2 - Machine head
4 - Trigger switch
9 - Cutting depth adjustor,
11- Bevel scale
16 - Bevel clamp handle
37 - Clamping knob;
39 - Pointer,
40 - Grub screw
47 – Bracket
4.4.2 Checking and adjusting the 45°mitre angle
Checking is performed as follows:
• Loosen the clamping knob 37 and rotate the
machine head 2 in the leftmost position. Tighten
the clamping knob 37.
• Pointer 39 should coincide with a mark of 45 °
on the bevel scale 11. If the angle does not match,
turn the screw 41 (Pic11) as required.
Pic11
2 – Machine head
6 – Movable guard
7 - Saw blade;
13 – Rotate table
37 – Clamping handle
38 – Setsquare
41 - Screw
4.4.3 Checking and adjusting the blade to the
fence
Perform as follows:
• Set the machine head 2 vertical
• Push the setsquare 38 against the guiding fence
12 and along the blade 7 (Pic2).
The angle should be 90 °.
• If adjustment is required, loosen the screw 42
and rotate the eccentric sleeve 15 until the face of
saw blade is flat against the square.
• Tighten the screw 42.
• Make sure that C mark on the rotate table 13
coincide with the 0 ° on both scales 14 (Pic13)
• If the adjustment is required, loosen the screws
43, and set the scale of the bevel in the correct
position. Fixed position of 45 ° should also
correspond to the correct angle. Pic12
Pic12
2 - Machine head 3 - Handle: 5 – Guard retraction
lever 7 - Saw blade, 12 – Fence
15 - Eccentric sleeve 38 - Set square 42 - Screw.
Summary of Contents for RDP-TS11
Page 86: ...86 www raider bg ...
Page 89: ...89 ...
