Raider RDP-TS11, User Manual

Page: 21 / 90

21
• Workplace should be well lit;
• do not work in environments with explosive
or chemically active medium;
• Do not allow children and unauthorized
persons stay at the work area;
• Working with the machine keeps a stable
position and do not try to reach objects that are
out of reach;
• During operation, avoid contact with
grounded devices (e.g. pipelines, electric
cookers, refrigerators, etc.);
• Do not stand in the work area of saw- blade!
Position you to the left or to right from it
• Stay alert, watch what you do, do not
operate a saw, if tired;
• Do not use damaged or deformed blades;
• Use only saw-discs recommended by the
manufacturer;
• Pay attention to the fact that the choice of
blade depends on what material will be treated.
• Pushing the material under the saw-blade, a
push stick must be used.
• Use the riving knife and adjust it properly;
• Use the upper saw blade guard and adjust its
position correctly;
• Do not force the machine during operation,
and in any case not take a lateral push on the
blade;
• Avoid overloading the saw;
• Do not attempt to cut too short workpiece;
• When sawing, in any case not to apply
excessive force to machine drive, do not force the
manufacturing process;
• Keep a clean workspace, the disorder in the
workplace can be cause injuries.
Even if the machine is operated correctly,
there may be the below dangers take place such
as:
• The risk of injury caused by uncovered
parts of the rotating saw blade.
• The risk of injury breakdown parts of the
workpiece;
• The risk from noise and dust;
• Electric shock hazard if not properly laying
electric cord.
Equivalent sound level meets the requirements
of GOST 12.4.051-87, add up to 89 dB (A).
To reduce the impact of noise from the work
of the saw, be sure to Use personal hearing
protection (earplug supplied).
The overall time of operation without PPE
noise should not exceed 4.8 hours per shift.
Make sure that the machine storage securely.
Keep it in a dry place and inaccessible to children.
Repair of the machine should be done by
a qualified technician with the designated or
substituted spare parts
3. Description
The machine presents an Electrical
mechanical device
The drive uses an asynchronous motor.
Rotation of engine to the cutting blade is passed
through a belt transmission.
Power saw is set from the single-phase AC
source with protective (grounding) wire.
Electric connection is shown on Pic.1. List of
major assemblies and parts, as shown on Pic.2, 3
4. Assembly and adjustment
Trouble-free blade depends on the proper use
and treatment and timely fixing shortcomings.
During preparation of the machine for operation
the following procedures must be followed:
• Unpack the machine and its basic parts;
• Assembly and installation the parts
• Set up the machine;
• Check and adjust the machine
• Start the machine.
4.1 Unpacking machine and basic parts
• Open the box and unplug the machine and
its basic parts.
• Identify the components of the machine use
the table 4 and picture 2 , 3
• All surfaces, covered with conservation
lubricant, must be wiped with cloth soaked in
white spirit and then dried.
4.2 Assembly and installation the basic parts
In order to compactness the new machine, it
must be packaged in saw bench mode position.
To operate the machine must be installed
supports and the blade.
4.2.1 Installing the supports (Pic4)
• Place the machine on the floor, the table
downstairs.
• Insert the support 23 (supports supplied) to
the appropriate landing lodgments, located in the
walls of the machine
• Secure the support 23 with screws, washers
and nuts (fixing 24 are supplied).
• Tighten the wing nuts.
• Set the machine to the normal (working)
position.
• If necessary, straighten the leg pad height.