Raider 40, Assembly Manual

Page: 5 / 80

Raider 40 Manual Military version
Section 1. GENERAL PRECAUTIONS
WARNING
Gasoline is extremely flammable and can explode if mishandled.
1. Before performing any service work on the fuel system, read and understand Section 1 - Service
Safety.
2. Before servicing the fuel system, disable the ignition system by removing all spark plug leads to
prevent accidental starting of engine.
3. Fuel leakage can contribute to a fire or explosion. After service work is complete and engine is
fully assembled, always run the engine momentarily to pressurize the fuel system. Then check for
leaks.
4. Never attempt to run the engine with any fuel system component removed or disconnected.
5. Check fuel hoses and other nonmetallic components for indications of damage or deterioration.
Always replace components with authorized factory replacement parts suitable for fuel systems.
6. Clean up fuel spills immediately and store rags in approved containers. Keep drained fuel in
approved containers for proper disposal.
7. When using compressed air to clean or dry parts, make sure the air supply is regulated not to
exceed 25 psi [172 kPa / 1.76 kg/cm
2
].
1.1 Checklist prior to Mission:
1. Fuel/Oil System 50:1 Mix in bladder
a. Fuels must be premixed.
b. Insure additive is placed in bladder if JP-5 or JP-8 is used (EPA)
2. Electrical System
a. Clean spark plugs, replace if necessary, check gap
b. Check condition of battery
c. Check stop switch operation
3. Control wires and linkage
a. Dewatering linkage works smoothly
b. Check state of linkages
c. Check choke control
4. Recoil starter
a. Check wear or damage on starter rope
b. Check state of ratchet gear
5. Clutch, propeller
a. Check wear or damage on propeller
b. Check condition of split pin
6. Other check points
a. Condition of trim tab (anode)
b. Corrosion or damage
2