Raider 40, Assembly Manual

Page: 39 / 80

-28-
Raider 40 Manual Military version
EMERGENCY STOP SWITCH AND LANYARD
The emergency stop switch and lanyard should be inspected and tested after servicing outboard. The
operator should perform Emergency Stop function test with the boat in the water prior to leaving the
launch area.
WARNING
Do not attempt to repair worn or faulty stop switch and lanyard. Replace only with genuine parts.
Do not substitute.
Inspection
1. Inspect lanyard (1) for cuts or fraying, lock clip (2) for cracks.
2. Inspect stop switch assembly
(3) For signs of wear and make sure the switch has adequate spring tension to hold the lanyard lock
clip in place
Stop Switch Test
1. Attach the lanyard lock clip to the stop switch.
2. Start the engine.
3. With engine running, puII the lanyard to disengage the lock clip.
Engine should stop running.
NOTE
The stop switch also operates as a push-button switch with the lanyard left attached.
4. Repeat the test but do not remove the lanyard. Press down firmly and hold the stop switch until
engine stops running. If engine continues to run in either test, the stop switch or wiring are
faulty and must be replaced before engine is operated.
3.10 Dewatering System
10-2
1. Lanyard P/N 361-06305-1
2. Emergency Kit Stop P/N 361-
06305-2