MicroRAE User’s Guide
27
Once you enter Programming Mode, the Calibration screen is shown. Press [MODE] to step
through the programming screens.
9.2. Enter Programming In Advanced Mode
To enter Programming Mode, press and hold [MODE] and [Y/+] until you see the Calibration
screen. No password is necessary in Advanced Mode.
Note:
Some parameters can only be viewed
or changed in ProRAE Studio II.
9.3. Menus And Submenus
In Programming Mode, menus and submenus are organized as shown here:
Calibration
Sensor On/Off
Clear
Datalog
Monitor Setup
Set Radio
Single Bump Sensor 1 On/Off
GPS On/Off* BLE On/Off
Single Zero
Sensor 2 On/Off
Set Site ID
WiFi On/Off**
Single Span Sensor 3 On/Off
Set User ID
Sent History**
Multi Bump Sensor 4 On/Off
Mesh Roaming Enable***
Fresh Air Cal
Radio On/Off***
Multi Span
Set PAN ID****
Exit
Set Channel****
Join Network****
Factory Reset****
Exit
* GPS-equipped version only.
** WiFi-equipped version only.
*** Mesh Wirelessly equipped version only.
**** Only available if Roaming is turned off.
