Configuration
–setup
There is provided a cut out in the OBD_Bridge body to allow for access to the usb connector after assembly of the
instrument.
In order to enter configuration mode – a serial terminal session
of 8,N,1 @ 57600
Baud should be opened to the
OBD_Brigde within
10s econds from powerup
. If more than 10 seconds has elapsed before the connection is
opened the serial terminal will receiver the diagnostic output from the OBD_Bridge – this will show the current
values and when the Bluetooth connection is established to the OBD software – it will show traces of the pids
received and sent.
Requirements
•
ANSI serial terminal software – I use Putty generally – free and works well
•
USB to MINI-USB cable
•
12V power supply for testing motor movement. – or on the bike.
•
CH340 / Arduino Drivers if not recognised by your PC.
Settings
•
Communication is 8 bits, No Parity, 1 Stop bit (8N1) and
NO FLOW CONTROL
( Off).
•
The port will depend on your computer – so plug it in and check what port appears.
•
Configuration mode is entered by holding down button A and turning on the power – the Gauge
reads the button states at power on and enters into configuration mode.
Open a serial terminal session to the meter port -
You should be presented with the following screen – if you are greeted with a flashing “o” in the top left corner – hit
the R key to “refresh” this will re-send the screen.
You should then see –
The menus are text driven and the Keys to use are at the start of each line – eg
•
R or r will refresh the display.
•
C or c will enter the Configuration Menu
•
P or p will enter the Parameter Menu.
Summary of Contents for V1.02 OBD-Bridge
Page 1: ...V1 02 OBD_Bridge Installation Manual Rae San 19 12 2019 ...
Page 20: ...GROUND ...
Page 26: ......
