RAE-SAN V1.02 OBD-Bridge, Installation Manual

Page: 17 / 31

The custom PID definitions in the setup I use are as follows.
As the output ranges defined for the sensors affects the value reported and hence the PID values sent, these are
shown in the other columns of the table to show the interdependence.
Standard PIDS
Standard Pids –
already defined
Custom Pids – need to be defined
PID Quantity OutMin OutMax unit Internal
range
Suggested Formula Min Max
0105 Coolant
TEMP
40.0 130.0 Deg C 0-3000 A - 40 -40 215
012F FUEL 10.0 100.0 % 0-1000 (100 *A)/255 0 100
015C OIL TEMP 40.0 150.0 Deg C 0-3000 A - 40 40 150
01B0
OIL
PRESSURE
7.0 100.0 PSI 0-2000
Int16(a:b)/10
(a*256+b)/10
0.0 110.0
0111 TPS 0.0 100.0 % 0-1000 (100 *A)/255 0 100
019C O2 SENSE 9.0 19.0 A/F 900-1900
Int16(a:b)/100
(a*256+b)/100
8.0 20.0
0142 Voltage 0.0 21.0 V 0..21000 Int16(a:b)/1000 0.0 21.0
010D SPEED 0.0 255 Km/h 0-255 Int8(a) 0.0 255.0
010C TACHO 0.0 16384 RPM 0-1000
(eg)
Int16(a:b)/4 0 16000
015E Engine Fuel
Rate
0.0 65536 l/hr 0-65.536 Int16(a:b)/20 0 65.5
01B3 Cooling Fan
On
0 1 - 0..1 A 0.0 1.0
01B1 High Beam 0 1 - 0..1 A 0.0 1.0
01B4 Low Fuel
Warn
0 1 - 0..1 A 0.0 1.0
01A6 Odometer 0.0 100000000 10cm Int32 Int32(a:b:c:d)/100 0.0 100000.0