10
(4) ID2: ID that sending data of channel 5-8
(5) ID3: ID that sending data of channel 9-12
(6) ID4: ID that sending data of channel 13-16
(7) Cycle Time: The cycle of actively sending channel data
(8) Active Mode: Active sending mode. When Active Mode is ticked, there is no need to send
the command to obtain data to the SBUS/PPM to CAN Protocol encoder, and the device will
periodically send channel data to the CAN bus at the time set by Cycle Time.
③
User Mode Parameters
(1) Length: User-defined data sending length
(2) Remote Request
(3) Cycle Time: The cycle of automatically sending channel data
(4) AutoSender: Automatic sending mode. When AutoSender is ticked, the device will
periodically send the set user data to the CAN bus at the time set by Cycle Time.
(5) ID: ID of sent data
(6) With Extended Frame not ticked, the ID range can be set from 0 to 7FF
(7) With Extended Frame ticked, the ID range can be set from 0 to 1FFFFFFF
Note: It is prohibited that all 7 bits are recessive. (Prohibited setting: ID=1111111XXXX)
(8) Data: The data to be sent
(9) Send: Send data key. Data is sent every time it is clicked.
