PG
12
PG
12
Test Installation cont.
To check
HEAT
mode:
1. Press the mode control and select HEAT.
2. Press the
+
button to raise the target temp to 90
o
F. Allow the system 2 minutes to respond.
3. Verify that heat is blowing from the system.
4. Return mode control to OFF
(leave OFF for 4 minutes before checking COOL).
To check
COOL
mode (do not operate AC if outside temp is below 65
o
F):
1. Press the mode control and select
COOL
.
2. Press the blue
-
button
to lower the cool target temperature to 50
o
F.
Allow the system 5 minutes to respond.
3. Verify that cool air is blowing from the system.
4. Return mode to OFF
Congratulations, you have successfully installed your unit. Please proceed to the
OPERATING Guide to initialize the CT80.
IMPORTANT:
After you have labeled and connected your wires, and followed the correct HVAC set-up,
if these check procedures do n
ot operate your system more info is available on our website at www.radiothermostat.com
or 877-602-5028.
eatures
