Radio Shack TAD-1018, Owner'S Manual

Page: 9 / 24

9
3. Thread a screw
into each hole
until it’s head
extends about
1
/
8
inch from the
wall.
4. If you are mounting the system on
a wall plate, thread the telephone
cord into the left slot on the top of
the mounting bracket and pull it
through the large hole in the cen-
ter of the bracket. If you mounting
the system directly on the wall,
thread the telephone cord into the
left slot on the top and bottom of
the mounting bracket.
Thread the adapter’s power cord
into the right slot on the top and
bottom of the mounting bracket.
5. Insert the mounting bracket’s tabs
into the slots on the bottom of the
answering system. Then push the
bracket up until it snaps into
place.
1
/
8
”
6. When mounting on a wall plate,
coil all the excess telephone cord
into the mounting bracket’s recess
by pushing it back through the
large hole. Leave only about 1–2
inches of the cord outside the
bracket.
7. Plug the telephone cord into the
wall plate or a modular phone
jack.
8. Line up the keyhole slots on the
bracket with the studs on the wall
plate (or with the screws in the
wall), then slide the bracket down
until it is secure.