31
4. Repeatedly press
or
to select
Set End Code
, and press
ENT/PGM
.
5. Repeatedly press
or
to select
Yes
or
Ignore
, and press
ENT/PGM
.
Note:
If you set the squelch so you hear a hissing sound, the scanner will remain on the
voice channel, even when a disconnect tone is transmitted or there is no signal at all.
frequently asked questions
These suggestions might help you locate the problem.
My scanner is on but will not scan, why?
•
SQUELCH
is not adjusted correctly; adjust
SQUELCH
.
• Only one channel or no channels are stored.
• Store frequencies into more than one channel.
Why won’t my scanner work at all?
• Check the batteries or make sure the AC adapter or DC adapter is connected properly.
• Recharge the rechargeable batteries or replace the non-rechargeable batteries.
• The AC adapter or DC adapter is not connected.
• Be sure the adapter’s barrel plug is fully plugged into the
9V 300 mA jack
.
Why doesn’t my keypad work?
The keylock function is activated. To turn off the keylock, press
/ KEYLOCK
until
disappears.
Why is
flashing?
Recharge the rechargeable batteries or replace the alkaline batteries.
Why am I getting poor or no reception?
Batteries are weak or completely discharged.
Check the batteries or make sure the AC adapter or DC adapter is connected properly.
Make sure an antenna is connected to the scanner.
Why does Error appear?
Programming error: re-enter the frequency correctly, including the decimal point.
Why won’t my scanner track a trunked system?
The transmission might not use a system that can be tracked by your scanner.
Scan another transmission.
The data frequency is missing: see “programming trunked frequencies.”
The system you are trying to track is a Type I system, and the scanner is set to scan Type II
systems. Set the scanner to receive Type I trunked frequencies. See “scanning type I and
hybrid trunked systems”.
Scanner is set to receive Type I trunked frequencies, but does not scan them. The fleet
map you have selected or entered might be incorrect.
Check the fleet map and correct it if necessary (see “scanning type I and hybrid trunked