22
frequency and Offset channel.
• MOT 800, MOT 800 CUSTOM require programming of fleet map.
• EDCS, LT require programming of frequencies in exact order and location.
3. Press
ENT/PGM
to go to Program Talk Group ID Mode.
searching a trunked bank
Once the data channel is acquired, the scanner begins a trunk scan. With the open mode
function, you will be able to find all the active talk groups within the trunked system.
Press
FUNC
, then
• /DELAY/OPEN/CLOSE
. You can switch to the trunk close mode from
the trunk open mode. See “scanning the talk group ID lists”.
While scanning conventional frequencies, follow the steps below to switch to the trunk
mode after the scanner finds the data channel.
1. Press
FUNC
, then
/BANK
to go to select bank menu in scan mode.
2. Press
TRUNK
in select bank menu to go to select open/close menu.
Set Open/Close
menu appear.
3. Press
or
to move the cursor up or down. To set Open/Close mode, press the number
key that corresponds to the desired bank.
4. Press
TRUNK
in select open/close menu to go to select Bank Menu.
5. To exit from menu mode, press
MAN/MENU
.
Hint
: While scanning in open mode, you may not know exactly to whom the talk group IDs
are assigned until you listen awhile. To locate talk group ID lists for your local police, fire,
and other agencies, refer to frequency guides available at your local RadioShack store or
on internet sites such as www.trunkscanner.com. You can also determine the type of
agency you are listening to after a short while, be it a police, fire, or emergency medical
2-way radio user. Once you have identified the type of service, note the associated talk
group ID of that unit for future programming. See “identifying a trunked frequency”.
Determining the service associated with a talk group ID might take awhile, but discovering
the ID owner of each signal is half the fun of trunk scanning!
turning a trunked bank on or off
1. Press
FUNC
, then press
/BANK
in scan mode.
2. Press
or
to move the cursor in the up or the down.
3. To turn banks on or off while scanning, press the number key (
1 - 9, 0
) that corresponds
to the bank you want to turn on or off.
4. To exit from menu mode, press
MAN
.
skipping a trunked bank
You can scan conventional frequencies programmed in the same bank by holding down
for about 1 second. If there is no conventional frequency, the scanner scans the next bank.
using Motorola control channel only mode
To turn this function on:
1. Press
FUNC
, then press
MENU
to open menu mode.
2. Select the “Trunk Option” - “Select Bank” - “Select Trunk Sys”.
3. Repeatedly press
or
to select Motorola system, and press
ENT/PGM
.
