6
In
s
ta
lla
ti
o
n
Directly on the Wall
You will need a drill and screws (not supplied) with heads
that fit the keyhole slots on the bottom of the system and the
mounting bracket.
1. Drill two holes 3
1
/
4
inches apart, one below the other.
2. Thread a screw into each hole, letting the heads extend
about
1
/
8
inch from the wall.
3. Insert the mounting bracket’s tabs into the slots on the
bottom of the system. Then slide the bracket up until it
snaps into place.
4. Plug one end of the supplied modular cord into the
LINE
jack on the back of the system.
5. Plug the other end of the cord into a modular wall jack.
6. Fit the heads of the screws into the keyhole slots on the
bottom of the system and the mounting bracket, then
slide the system down until it is secure.
C
ONNECTING
THE
H
ANDSET
Plug one end of the supplied coiled cord into the modular
jack on the left side of the phone, and plug the other end
into the modular jack on the handset. Then place the
handset on the cradle.
U
SING
AC P
OWER
Connect the supplied AC adapter to the
DC 9V
power jack
on the back of the phone. Then, plug the other end of the
adapter into a standard AC outlet.
Ô
The answering system cannot operate without AC power.
However, you can make and answer calls with the
telephone handset without AC power.
When you first connect power,
Initialization
,
12:00 AM
, and
1/01
appear. The system runs a self test, sets all internal
default values, and then sounds 4 tones.
Ô
NOTES
Ô
•
Always connect the AC adapter
to the system before you
connect it to AC power. When
you finish, disconnect the
adapter from AC power before
you disconnect it from the
system.
•
Use only the supplied Class 2,
Regulated 120V AC, 60Hz; 9V
DC, 500 mA, Positive (+) Tip AC
Adapter. Use of any other
power source may cause
damage.
DC 9V Power Jack
