Radijator TKAN Integra Series, Instruction Manual

Page: 84 / 93

84
Possible cause 3

PROBLEM 3 – Space deep in the furnace where pellets are combusted is full of
uncombusted remnants, that is cinders, therefore, there is no contact between pellets
and hot air.

How to solve PROBLEM 3 – Clean the depth of the furnace, primarily larger cinders
mechanically and smaller cinders can be vacuumed.
Possible cause 4

PROBLEM 4 – Pellets used are highly moist.

How to solve PROBLEM 4 – Try drier pellets.
Possible cause 5

PROBLEM 5 – Mains voltage to which the boiler is connected is significantly lower
than 220-230V, therefore the power of the heater is lesser.

How to solve PROBLEM 5 – Priključiti mrežni ispravljač napona ili potpaliti ručno.
Possible cause 6

PROBLEM 6 – The boiler is switched from automatic to manual operation mode. If
during the entire ignition phase, the heater light isn’t on, then the boiler is certainly in
manual mode.

How to solve PROBLEM 6 – Refill pellets.
Possible cause 7

PROBLEM 7 – The boiler is switched from automatic to manual operation mode. If
during the entire ignition phase, the heater light isn’t on, then the boiler is certainly in
manual mode.

How to solve PROBLEM 7 – Switch the boiler to the automatic ignition mode.
Possible cause 8

PROBLEM 8 – The electric heater malfunctioned. Disconnect the boiler from mains
voltage and measure the electrical resistance of connection cables of the electric heater.

How to solve PROBLEM 8 – Replace the electric heater.
Group II
Possible cause 1 .

PROBLEM 1 – Fan speed in the ignition phase. Fan speed for primary air in this phase
is determined by parameters Uc00 and Uc01. If the speed is drastically changed in
comparison to the factory set one, it is not good to either drastically decrease or increase
it. In case the fan, while igniting, is weak, the temperature of flue gases doesn’t increase
and if it is too powerful, it is possible to rapidly consume pellets in the chamber which
leads to decreasing temperature of flue gases while igniting.

How to solve PROBLEM 1 – Set values of parameters Uc00 and Uc01 to the factory
values or near-factory values.