16
1143923-W2-E
21.
Fit the concealing plate to the concealing
ring.
22.
Refit the control lever.
Note!
Push the control
lever firmly while tightening the grubscrew.
23
Fit the shower fittings, refer to your shower
fittings installation and user guide for
instructions.
Important!
For high pressure systems (above
0.5 bar) make sure that the flow regulator
(supplied) is fitted, refer to section:
‘Flow
regulators’
.
24.
Turn on the hot and cold water supplies and
check for leaks.
25.
Before using the shower, refer to section:
‘Commissioning’
.
V10 Contract Pack (with Adjustable
Elbows)
The adjustable elbows each have adjustment of
10 mm, allowing your thermostatic mixer to be
connected to pipe centres ranging from 133 mm
to 153 mm.
The adjustable backplate allows an additional
11 mm adjustment from the finished wall surface
and should be fitted with the cutout in line with the
outlet.
Installation
1.
Draw a centre line between the inlet pipework
and, using the adjustable backplate as a
template, mark the position of the adjustable
backplate fixing holes.
2.
For solid walls drill the holes for the backplate
with a 6 mm drill and insert the wall plugs
(supplied). For other types of wall structure
alternative fixings may be required (not
supplied).
3.
Secure the backplate to the wall using the
screws (supplied).
4.
Align the mixer with the pipework and fit onto
the backplate.
5.
Tighten the compression nuts onto the mixer
with a suitable spanner.
Caution!
Take care not to damage the chrome
surfaces.
6.
Tighten the adjustable backplate grubscrews
with a 2 mm hexagonal key (supplied) to
secure the mixer to the backplate.
7.
Refer to the Thermostatic Mixer and Shower
Fitting Installation and User Guide for further
installation and commissioning procedures.
Grubscrew
11 mm
10 mm
Adjustable
Elbow
Adjustable
Backplate