7.3.3. ETH
* Active only when Router mode
Fig. 7.6: Menu Ethernet
IP
Default = 192.168.169.169
IP address of ETH interface
Mask
Default = 255.255.255.0
Mask of ETH interface
Default GW
Default = 0.0.0.0
The default gateway (applies to whole RipEX). It can be set only in the Routing menu while Router
mode.
DHCP*
List box: Off, Server
Default = Off
Server
DHCP (Dynamic Host Configuration Protocol) Server in RipEX sets network configuration (IP address,
Mask, Gateway) in connected DHCP clients. They have to be connected to the same LAN as the ETH
interface of RipEX. The Mask set is the same as on RipEX ETH, the Gateway is the IP address of ETH
interface of RipEX. Typical DHCP client is e.g. a PC used for configuration of RipEX.
Important!
Never activate the DHCP Server when ETH interface of RipEX is connected to LAN, where
another DHCP server is operating.
•
Start IP
Default = IP address of ETH int 1
DHCP Server assigns addresses to connected clients starting from this address.
85
© RACOM s.r.o. – RipEX Radio modem & Router
Advanced Configuration
