Underlined parameters are described in Common parameters.
Mode of Connected device
Master
Broadcast
Note: There is not the possibility to set Broadcast address, since
Cactus broadcast messages always have the address 0x00. Hence
when the Broadcast is On, packets with this destination are handled
as broadcasts.
Address translation
Table
Mask
Slave
Broadcast accept
•
Max gap timeout [ms]
Default = 30
The longest time gap for which a frame can be interrupted and still received successfully as one
frame. It should not be set below 10ms, while 15–40 ms should be OK for a typical Cactus protocol
device.
ITT Flygt
ITT Flygt is a serial polling-type communication protocol used in Master-Slave applications.
ITT Flygt protocol configuration uses all parameters described in
Common parameters
.
Mode of Connected device
Master
Broadcast
Note: There is not a possibility to set the Broadcast address, since ITT
Flygt broadcast messages always have the address 0xFFFF. Hence when
the Broadcast is On, packets with this destination are handled as broad-
casts.
•
First Slave Address
Default = 1
Slave addresses are not defined in the ITT Flygt protocol. However
Slave addresses have to be defined in the RipEX network. This is the
First Slave address in decimal format.
•
Number of Slaves
Default = 1
Since the ITT Flygt protocol Master (centre) polls the Slaves (remotes)
one by one without any addressing, number of slaves has to be defined.
Address translation
Table
Mask
RipEX Radio modem & Router – © RACOM s.r.o.
102
Advanced Configuration
