- 13 -
6. Push the choke lever down to the run position (warm start).
7. The engine may start, or it may be required to pull on the recoil starter until
the engine starts.
8. Allow the engine to run idle for around 10 seconds to let it warm up.
9. Pull the trigger to start the operation.
10. You can set the throttle control position to lock the trigger in the operating
position. To unlock the trigger, pull the throttle control or push the trigger.
To stop:
1. Release the throttle trigger and allow the engine to idle for a few moments.
2. Move the ON/OFF switch to the OFF position (O).
3. The engine will now stop.
c. Blower mode
-
Inspect the work area before starting. Remove any debris or objects that
could be thrown or those that can get caught or obstruct the device.
-
Put the shoulder strap.
-
Hold the machine by the handle. Walk and hold the tube just above the
ground and blow the debris.
-
Work in order to gather the debris in one or more lots. Use the vacuum mode
to collect the heap. You can also pick up the pile of debris with a broom (or
rake) and a shovel.
-
Throw away the debris in a trash bin.
d. Vacuum mode
IMPORTANT!
Do not vacuum wet debris (they must be dry), nor large and hard
objects that may damage the machine (stones, cans, pieces of wood
too large, etc.).
Do not vacuum flammable objects, and objects on fire.
The collection bag must always be set during suction.
-
Inspect the work area before starting. Remove any debris or objects that
could be thrown or those that can get caught or obstruct the device.
-
Put the shoulder strap.
-
Hold the handle of the tool and the tube to raise and maintain the machine.
-
Put the tube to the ground without putting it in the debris. Move while sucking
debris.
When the collection bag is filled, stop working and empty the bag.
