Step SR2:
Install Sim Risers to Chassis
Hardware:
● 8 x 16mm Standard Bolts
● 8 x Standard Spring T-nuts
1. Using 16mm M8 bolts facing upwards feed through the holes
2. Loosely attach T-nuts to the tops.
3. Lift up the sides of the chassis as needed to slide each sim riser assembly into the
bottom T-slot channel. Tighten down all bolts once in the desired position.
Once installed, you can place floor sliders fabric side down, rubber side up UNDER the
rubber feet.
This allows you to be able to move your rig around by sliding it. It also protects
your floors.
Page 12
RCP Cockpit PRO Manual (v.02/2024.1)