![background image](http://html1.mh-extra.com/html/racal-instruments/1260-30-series/1260-30-series_manual_3133317028.webp)
User Manual 1260-30
Module Specific Syntax 3-2
The valid values of <group number> and <channel> for the
different 1260-30 configurations are as follows:
Configuration
One 1 x 40
Two 1 x 20
Four I x 10
Eight 1 x 5
<channel>
00-39
00-19
00-09
00-04
<group number>s
0
0,1
0,1,2, and 3
0,1,2,3,4,5,6, and 7
Refer to Figure 3-1 for connector pin configurations, and to Figure
3-2 for the command codes required to open and close the various
<channels> for the four configurations.
CLOSE Command
The Module Specific Syntax for the CLOSE command is the same
as for the OPEN command.
Example: OPEN 3.002
This open command will open channel 2 in Group 0 on the 1260-
30 module at switch card address 3.
PSETUP
Command
The PSETUP command causes the specified module setup to be
transmitted to the VXI Controller. The syntax used is:
PSETUP <module address>[;<module address>] [;<module
address>] where <module address> is the switch card address.
The responses to the PSETUP command for the 1260-30A Signal
Multiplexer/Scanner is as follows:
<module address>. 1260-30A 40-channel Signal Multiplexer/Scanner
Module
<module address>.BBM
<module address>.END
1260-30B:
<module address>. 1 260-30B 20-channel Signal Multiplexer/Scanner
Module
<module address>.BBM
<module address>.END
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com