User Manual 1260-30
Module Specific Syntax 3-3
1 260-30C:
<module address>. I 260-30C 10-channel Signal Multiplexer/Scanner
Module
<module address>.BBM
<module address>.END
I 260-30D:
<module address>. 1260-30D 5-channel Signal Multiplexer/Scanner
Module
<module address>.BBM
<module address>.END
The response to the PSETUP command consists of a header on
the first line. The header describes the model number followed by
an A or B designating four or two-wire, respectively. The next line
designates the setup mode for scanning which, by default, is
Break-Before-Make (BBM). The last line containing the 'END
1
'
characters denotes no more information to report.
PDATAOUT
Command
The PDATAOUT command causes the specified module to
transmit the CLOSED state of the relays within the switching
module to the 1260 Controller. The syntax used is:
PDATAOUT <module address>[.<module address>] [;<module
address>]
The responses to the PDATAOUT command is as follows:
1 260-30A:
<module address>. 1260-30A 40-channel Signal Multiplexer/Scanner
Module
<module address>.<channel>[,<channel>] [,<channel>]
<module address>.END
1260-30B:
<module address>.1260-30B 20-channel Signal Multiplexer/Scanner
Module
<module address>.<channel>[,<channel>] [,<channel>]
<module address>.END
1260-30C:
<module address>. 1260-30C 10-channel Signal Multiplexer/Scanner
Module
<module address>.<channel>[,<channel>] [,<channel>]
<module address>.END
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com