Distributor of Digi International: Excellent Integrated System Limited
Datasheet of 101-1274 - KIT DEV STANDARD RCM5700
Contact us: [email protected] Website: www.integrated-circuit.com
MiniCore RCM5700/RCM6700 User’s Manual
digi.com
21
The Digital I/O accessory board needs to be installed to run the
SWITCHLEDS.C
and the
SERIAL-
TOSERIAL.C
sample programs. This accessory board is included only with the Deluxe Develop-
ment Kit.
To install the Digital I/O accessory board, insert the strip of header pins included with the acces-
sory board into the socket at J12 on the bottom side of the Digital I/O accessory board. Then line
up the Digital I/O accessory board with the Interface Board standoffs/connectors and install the
Digital I/O accessory board pins into socket J2 on the Interface Board. Secure the Digital I/O
accessory board with the long plastic standoffs/connectors from above as shown in Figure 3-6.
Figure 3-6. Install Digital I/O Accessory Board
Pins 1–2, 3–4, 5–6, and 7–8 on headers JP5 and JP8 on the Digital I/O accessory board must be
jumpered. Pins 2–4 and 3–5 on header JP7 on the Digital I/O accessory board must also be jump-
ered.
•
SWITCHLEDS.C
—monitors switches S1, S2, S3, and S4 on the Digital I/O accessory board and
lights LEDs DS1–DS4 when the corresponding pushbutton switch is pressed. LEDs DS1–DS2
on the Digital I/O accessory board are controlled by PA4–PA7, and switches S1–S4 are con-
trolled by PB4–PB7 respectively.
22 / 113
22 / 113
