Distributor of Digi International: Excellent Integrated System Limited
Datasheet of 101-1274 - KIT DEV STANDARD RCM5700
Contact us: [email protected] Website: www.integrated-circuit.com
MiniCore RCM5700/RCM6700 User’s Manual
digi.com
15
2.2.3 Step 3 — Connect USB Cable
The USB cable connects the RCM5700/RCM6700 to the PC running Dynamic C to download
programs and to monitor the MiniCore module during debugging. It also supplies power to the
Interface Board and the MiniCore via the USB interface.
Connect the USB cable between USB connector J5 on the Interface Board and your PC as shown
in Figure 2-4. Note that the USB cable connectors are different at either end, so there is only one
way to connect them between the PC and the Interface Board.
Figure 2-4. Connect USB Cable
Your PC should recognize the new USB hardware, and the LEDs next to the USB connector on
the Interface Board will flash — if you get an error message, you will have to install USB drivers.
Drivers for Windows XP are available in the Dynamic C
Drivers\Rabbit USB Programming
Cable\WinXP_2K
folder — double-click
DPInst.exe
to install the USB drivers. Drivers for
other operating systems are available online at
www.ftdichip.com/Drivers/VCP.htm
.
The green power LED on the Interface Board should light up when you connect the USB cable.
The MiniCore and the Interface Board are now ready to be used.
NOTE:
A
RESET
button is provided on the Interface Board above the Ethernet jack to allow a
hardware reset without disconnecting power.
NOTE:
Pins 1–2 on header JP1 on the Interface Board must be jumpered to download and debug
applications and sample programs with Dynamic C running. Pins 1–2 should be left
unjumpered to
run
an program already loaded in flash memory.
CAUTION:
Do not jumper pins 1–3 on header JP1 on the Interface Board.
16 / 113
16 / 113
