STL360 Kit Assembly and Wiring
STL360 floodlight kits come pre-wired and assembled
on the RAB CU4 EZ plate, allowing for mounting on round,
rectangular or octagonal surface or recessed boxes.
Mounting
Wiring
STL360 Kit
Assembly
and Wiring
1. Attach the Universal Mounting bar with the bar screws
(provided) to the junction box. If you are attaching your
STL360 kit to a surface mount weatherproof box, you
must use both gaskets, with the metal mounting plate
sandwiched between.
2.
Easy Wiring Tip:
Use the “S” shaped Hands
Free Hanging Hook to hold
the EZ Plate during wiring.
3. Bring power leads and
sensor kit leads through
holes in all gaskets into
junction box.
4. Strip
1
/
2
" of insulation from all leads.
5. Attach ground wire(s) to junction box grounding screw.
Connect as shown in wiring diagram on page 7.
6. Twist on wire nuts. Secure with electrical tape.
7. Align gaskets, EZ Plate and metal mounting plate to
insure proper seal. Tighten EZ Plate center screw (make
sure O-Ring gasket is on the screw) to attach EZ Plate
to the box.
8. Insert plastic Finishing Cap in the center of the CU4
EZ Plate for a weatherproof seal.
9. Use silicone sealant around all openings to insure a
weatherproof seal.
10. Screw in light bulbs. Turn on power. Conduct walk test
to adjust sensor response (see page 15).
Insert
close-up
plug in
unused
hole
Finishing
Cap
Metal Mounting
Plate
Bar Screws
Gasket
Universal
Mounting
Bar
Gasket
O-Ring
Gasket
8
Hook rests in
notch on
crossbar
Hands Free
Hanging
Hook
Black
Black
Red
Red
(pigtail)
Ground
Ground
Power In
White
White
Red pigtail is only
used to switch remote
or additional fixtures.
STL360H
STL360Q2W
STL360Q1
STL360Q3W
STL360HBW
CU4 EZ Plate
Center
Screw
7
CU4 EZ Plate
