STL360 Assembly and Wiring
■
To install a STL360 Sensor with separately
purchased floodlights, start at #1.
■
To install STL360 Pre-wired Floodlight Kits,
see page 7.
1. Screw the threaded arms of each floodlight into the
RAB CU4 EZ Plate. ( See diagram on page 7)
2. Screw the threaded arm of the sensor into the bottom
hole of the EZ Plate. Sensor should be below and as far
away from the floodlights as possible.
3. Attach the Universal Mounting bar with the bar screws
(provided) to the junction box. If you are attaching your
STL360 kit to a surface mount weatherproof box, you
must use both gaskets, with the metal mounting plate
sandwiched between.
4.
Easy Wiring Tip:
Use the “S” shaped Hands Free Hanging Hook to hold
the EZ Plate during wiring.
5. Bring power leads, light fixture and sensor leads through
holes in all gaskets and mounting plates into junction box.
6. Attach ground wire(s) to junction box grounding screw.
7. Position EZ Plate gaskets and metal plate. (see pg #7)
8. Strip
1
/
2
" of insulation from all leads. Connect as shown
in wiring diagram.
9. Twist on wire nuts.
Secure with
electrical tape.
10. Make sure all unused
openings in EZ Plate are
closed with plugs (provided).
11. Screw in light bulbs. Turn on power.
12. Conduct Walk Test to adjust sensor response (see
page 15).
STL360 Assembly and Wiring
Multiple Sensors
Multiple sensors may be wired together, but doing this will
make problems difficult to troubleshoot. Single sensors
that control their own lights will give a more accurate
location of movement and trouble-free operation.
Multiple Fixtures
Multiple fixtures may be
wired to a single sensor.
To handle loads greater
than 1,000 watts,
a qualified electrician
should install
a relay.
Power
Quality
It is not recommended to install sensors on a circuit that
also feeds motor loads such as HVAC equipment, kitchen
appliances, or garage door openers. The Stealth circuit is
surge and transient protected to IEC specifications.
However, if voltage varies significantly from 120 volts,
which may occur on circuits with motor loads, the sensor
may malfunction.
10
Power In
White
Red
Black
Power In
White
Sensor
Red
Black
9
Black
