![background image](http://html.mh-extra.com/html/rab-lighting/rddled2r/rddled2r_installation-instruction_3110876004.webp)
Thank you for buying RAB lighting fixtures. Our goal is to design the best quality products to get the job done right. We’d like to hear your comments.
Call the Marketing Department at 888-RAB-1000 or email: [email protected]
REMODELER & NEW CONSTRUCTION TRIMLESS
2IN 10W ROUND & SQUARE INSTRUCTIONS
IMPORTANT
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE
.
RAB fixtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper grounding
is required for safety. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A
PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.
WARNING: Make certain power is OFF before installing or maintaining fixture.
RDDLED2R
RDDLED2S
Fig: 1
ROUGH-IN MOUNTING FOR
ND2RTL & ND2STL
For round ceiling cut out 3-3/16” dia. For square ceiling use
the 3-3/16” sq cut out template from packaging material.
1.
Nailer bars
are provided for use with wood joist
installations. Insert through nailer bar slots and secure
accordingly.
2.
Butterfly brackets
provided to use C-Channels.
(optionally available, consult factory). Consult local
building codes for final support of fixture.
3. The fixture can be mounted into max 3/4” ceiling
thickness. For height adjustment, loosen the
Wing Nut
and slide the
Butterfly Bracket
. If necessary remove the
Wing Nut
and insert in screw in different hole provided
on the
Butterfly Bracket
. (Fig: 1)
4. Adjust both the
Butterfly Brackets
such that the frame
of
Rough-In Section
is flush with the finished ceiling
surface. Tighten the
Wing nuts
.
5. Drop down
Supply Wires
must be atleast 9” long to
allow fixture removal.
6. Loosen the
Junction Box Screw
and open the
Junction
Box
(Fig.2). Attach
Supply Wires
into
Junction Box
and
connect to the fixture. See wiring section for details.
7. Push up and slide the
Junction Box
section into the
ceiling. Be sure the
Spring Clips
is snapped in
and
Trim
Ring
is flush and secure. Allow the Junction Box section
of housing to rest on the
Leg
support of the
Rough-in
Section
.
Butterfly Brackets
Nailer Bar
Wing Nut
SURFACE PREPARATION
•
This fixture can be installed with minimum plenum height of 5”.
•
The fixture can be used to replace an existing unit or for new construction.
•
Cutout must be accurate not undersized or oversized. A hole saw is recommended.
CEILING CUT OUT MUST BE FREE
OF ANY DEBRIS AND BURRS.
Rough-in
Section
Supply wires
Junction Box
Screw
Junction Box
Leg
Fig: 2
Trim Ring
Spring Clip
WARNING: Suitable for wet locations with covered ceiling mount.
WARNING: Suitable for installation in Non-Accessible and Accessible Ceilings.
WARNING: Suitable for installation in Non-Insulated Ceilings.