‘’
Slim Light ‘’ SERIES FOR MAINTAINED / NON-MAINTAINED LUMINAIRES
Thank you for purchasing this product of
O l y m p i a E l e c t r o n i c s . A E u r o p e a n
manufacturer.
GENERAL
o
These luminaires are used indoors
(
ta 40 C
)
where emergency light is needed.
E a c h l u m i n a i r e m u s t b e p e r m a n e n t l y
connected to mains power supply
.
In normal
operation the illumination LEDs are lit as well
as the green indicating charge LEDs when
the battery is charging.
In case of a mains power supply failure the
luminaire will light the led strip automatically
in emergency mode. When the mains power
supply is restored the device turns to normal
operation.
Maintained / non-maintained operation
there is an option to select the maintained or
non-maintained operation by placing the
jumper to the appropriate place according to
the figure 3 (page 2)
.
INSTALLATION
To install the luminaire follow the installation
instructions on page 2.
ΑΤΤΕΝΤΙΟΝ
!!!
1. Operations for installation, maintainance or
testing must be done by authorized personel
only
.
2.
The device must be connected to the
mains power supply thru a fuse dependent by
the total amount of the line’s power load
.
3.
It is sugested to check every month the
indication LED for battery charging, and by
pushing the TEST button to check the
emergency circuit. The led strip should light as
long as the TEST button is pressed.
4.
It is sugested to check every 6 months the
m i n i m u m a u t o n o n o u s d u r a t i o n b y
disconnecting the mains power supply
.
Count
the time that the led strip lights and in case of
less time than the minimum autonomous
duration the battery must be replaced. If the
measured time is considerably less than the
minimum autonomous duration
In case of battery or led strip
replacement, these must be replaced by parts
of the same type,
by the manufacturer or
by a
competent person.
t i
in battery recycling
points.
Do not incinerate.
If the
luminaire doesn’t work as described above
contact the installer.
contact the
installer.
5.
In case of inactive use for a period greater
than 2 months, disconnect the battery by
pulling out the battery’s connector.
6.
I s not allowed to discard batteries in to
common trash bins, they must be
discarded only
TECHNICAL CHARACTERISTICS
OPERATION TEMPERATURE RANGE
RELATIVE HUMIDITY
EXTERNAL DIMENSIONS
CONSTRUCTION MATERIALS
TYPICAL WEIGHT
GUARANTEE
OPERATION VOLTAGE
MAXIMUM POWER CONSUMPTION
BATTERIES
(
Ni-Cd
)
CHARGING TIME
INDICATIONS
-
CONTROLS
MINIMUM AUTONOMOUS DURATION
DEGREES OF COVER PROTECTION
PRODUCED IN ACCORDANCE WITH
ILLUMINATION
(230V AC
/ emergency)
ILLUMINATION SOURCE
1.5 h
3
h
24 h
Battery charge indication LEDs
,
TEST button
IP 20
12
white LED’s
EN 60598-1, EN 60598-2-22
, ΕΝ 55015, ΕΝ 61547, ΕΝ 61000-3-2, ΕΝ 61000-3-3
5 to 40 C
o
Up to 95%
Bayblend FR3010
,
transparent
polycarbonate
3 years
(1
year for the battery
)
24
0
x 90 x 44 mm
345gr.
220-240V AC/50-60Hz
350gr.
High Quality European based Manufacturers
GR-8/leds
GR-9/leds
3.6V/0.6Ah
3.6V/1Ah
2.7W / 3VA
3W / 3.5VA
35lm / 85lm
32lm / 85lm
923378
005
_23_001
Page 1 from
2
