44
/ 54
User Manual
Rev. 2.0 - 27/01/20
TEX3500LCD
• Place the RF module into its place and resolder points
B
.
• Place an ammeter in series to 50 VDC (see points
D
). Verify, with the
equipment turned on but without power, that there are 1 A otherwise
you must intervene on the trimmer
E
up to the indicated value
reading. However, if the ammeter does not provided any information,
it is very probable that the fuse is broken.
Proceed with its replacement, following the next chapter.
D
E
• Redo all previously steps, performed in reverse, in order to reassemble and fix
the module in place.
• Replace the cover and tighten all the screws necessary to close it.
8.4.3 How to replace the fuses
• Open the top cover of
TEX3500LCD
by unscrewing all the screws.
• Identify the broken fuse.
