7 / 30
User Manual
Rev. 1.2 - 21/01/11
TEX2000LCD
5.1.3 Connections
Connect the RF output of the transmitter (see figure 6.2 - note [21]) to the antenna
cable or a dummy load capable of dissipating amplifier output power. To begin
with, set exciter to minimum output power and switch it off.
Connect the transmitter INTERLOCK IN input to the matching INTERLOCK OUT
output fitted on R.V.R. Elettronica equipment to act as hybrid couplers. If your
equipment is a different brand, identify an equivalent output.
WARNING: Electric shock hazard! Never handle the RF output connector
when the equipment is powered on and no load is connected. Injury or death
may result.
Ensure that the POWER switch on the front panel is set to “OFF”.
Assicu rarsi che l’interruttore POWER nel pannello frontale sia regolato in posizione
“OFF”.
Connect the mains power cable to the MAINS connector on the rear panel.
Note:
The mains must be equipped with adequate earth connection properly
connected to the equipment. This is a pre-requisite for ensuring operator safety
and correct operation.
Note:
the section of the power supply cable must be not less than 2,5 mm and
the plug must be of adequate power.
WARNING: The power supply connector is a terminal box. Ensure that the
wire is not live before performing the connection.
Connect the audio and RDS/SCA signals from user’s sources to the transmitter
input connectors.
