![background image](http://html1.mh-extra.com/html/r-tech/tig401-tft/tig401-tft_operation-instructions-manual_4325046024.webp)
24
REMOTE
This is where you select how machine is triggered to start and remote control of amperage if required.
2T
-
Press trigger to start weld, release to finish weld.
4T
-
Press and hold trigger to start weld at start amps, release trigger to go to
main amps. To finish weld
-
Press and hold trigger to go to end amps, release
and weld will stop.
PEDAL
-
Press foot pedal to start weld, fully depress pedal to get 100% of
amps shown in recommended settings.
I.E If recommended setting was 120A, on a full depress of pedal you will get
120A, if pedal only pressed halfway you will get 60A
4T+F
-
Torch trigger latch operation same as 4T but with amperage control by
slider / rotary knob on torch handle.
2T+F
-
Torch trigger operation for on/off with amperage control by slider /
rotary knob on torch handle.
Once required remote setting is selected, press right arrow to move to OK
(You can also press the HOME button)