2. Remove cap and begin draining, squeeze
"C"
to control flow. (See picture below)
3. Open the top "recovery tank lid" and flush out with
fresh water to keep tank clean. Rinse the recovery tank
after every use. This will prevent heavy build up on the
bottom of the tank, foul odors and clogging of the drain
hose. Empty "Drain Saver".
Always empty recovery tank when refilling the solution
tank. To drain the recovery tank, perform the following
steps.
1. Remove drain hose
"B"
and unscrew cap. Open the
top "recovery access lid" and flush out with fresh water
to keep tank clean. (See picture below)
4. Once tank is empty, put the cap back on and place
hose back on hook.
Drain Solution Tank
To drain left over cleaning solution from the solution tank,
perform the following steps.
1. Pull the clear sight tube/drain hose
(A)
off barbed fitting.
(See picture below)
2. Rinse out tank and solution flow system with clean water.
C
* It is the customers responsibility to verify that discarded
water is in compliance with local, state, and federal
laws.
DO NOT DRAIN INTO "STORM DRAINS" !
Drain Recovery Tank
Overide Parking Brake
The parking brake must be released "prior" to attempting to
"push/pull"
the machine manually
. Perform the following
steps in any order.
1. Disconnect both positive and negative leads
(1 & 2)
from
the traction motor. (See picture below)
2. Turn wingnut
(3)
clockwise to release the parking brake
.
(See picture below)
PAGE 22
A
B
1
2
3
