Recovery Tank
Drain Saver
Recovery Tank
Float Shut-Off
When water is no longer being vacuumed
from the floor and the vacuum fan is
operating, the ball float has engaged the red
high recovery light
(1)
will come on.
(See picture below)
The vacuum motor will not vacuum water with
recovery tank full. The recovery tank must be
drained
1. The float shut-off
(2)
screen can be
cleaned in or out of the machine.
2. To clean the float shut-off while it is inside
the machine wipe material off screen
then rinse. Check that the ball is also
clean and moves freely.
3. To remove the float shut-off, remove the
white clamp
(3)
grasp the screen with one
hand and pull down to remove.
4. Screens, gaskets, and shutoff balls must be
in place.
The recovery tank drain saver will help prevent the drain
from becoming clogged with debris.
1. The drain saver screen should be emptied and cleaned
after you drain the tank.
2. To clean, pull hose
(4)
out of drain saver and remove
screen. Empty screen into trash, wipe material off screen
and then rinse.
3. When finished place screen back into the recovery tank
and re-insert hose into screen
(5)
.
4. The screen saver must always be in place when the
machine is in use to prevent clogging of drain.
PAGE 23
1
4
5
2
3
