R.P.S. Corporation 200, Operator'S Manual

Page: 13 / 25

Connecting batteries
Your machine is equipped with (3) 12 volt, Deep cycle 210, amp hour batteries or, an optional (six) 6 volt, Deep cycle, 245
amp hours batteries, which Form a 36 volt system.
1. Turn all switches to the off position and remove key.
2. Hinge open the battery access lid to access the battery compartment.
3. All of the battery cables are connected to the batteries. Locate any loose ones and connect to the open terminal.
Tighten with 9/16" wrench.
(see below)
4. Turn on main power switch and check the battery condition meter to ensure correct installation. Charge batteries if
needed.
(see: battery charging)
PAGE 9
Machine Preperation
Uncrating machine
Carefully check the crate for any sign of Damage. Batteries are in the unit. To uncrate the machine, remove banding from
around the crate. Take off the top and sides And dispose of properly. Remove banding from machine. Remove the
chocks around the drive wheels. Fold down ramp, and roll machine off of the base. Notify the carrier immediately if
concealed damage is discovered.
Optional (6) 6-volt 245 ah
Standard (3) 12-volt 210 ah