R.P.S. Corporation 200, Operator'S Manual

Page: 16 / 25

Battery charging
Charger speccifications
Output voltage of 36 volts.
Output current of 25 amps max.
Input voltage of 110 volts/60 Hz.
Automatic shut off circuit.
Made for deep cycle batteries.
Danger:
always charge batteries in a well ventilated area.
Batteries emit hydrogen gas. Explosion or fire can result. Keep
sparks and flame away. Shield eyes when servicing batteries
and avoid contact with battery acid.
Leave rear hood open
when charging!
1. Transport machine to a well ventilated area for charging.
2. Turn the machine off.
3. Hinge opens the battery access hood to expose the
batteries. (Caution: always wear eye protection when batteries
are exposed)
4. Check the water level in each battery. Do not charge the
machine unless the water is slightly higher than the plates. If
needed, add enough distilled water to just slightly cover the
plates. Do not over fill. Batteries can overflow during charging.
Replace caps before charging.
5. With the grey charger plug disconnected from the machine,
plug the charger power cord into a grounded 110 volt standard
wall outlet.
6. Connect the grey charger plug into the battery charging
port located on the lower portion of the steering tower.
7. The charger will automatically begin charging, and
automatically shut off when fully charged (check gauge)
8. After the charger has turned off, unplug the grey charger
plug from the machine and disconnect the charger from the
wall outlet.
9. Recheck the cell level after charging. If needed, add
distilled water up to the correct level. Be certain to replace the
caps securely and to wipe off the top of the batteries with a
clean cloth.
PAGE 12
CAUTION: The following instructions are intended for the 36v charger
supplied with the machine. Do not use any other charger with this machine.
Gray charger
plug