MedTrack CR60 Rehabilitation Treadmill Service Manual
Repair/Replacement and Calibration 4-27
Replacing the Controller Cable
1. Disconnect the power and remove the hood as described on page 4-3.
2. Remove the controller assembly as described on page 4-24.
3. Cut any cable ties that fasten the controller cable to the headframe.
4. Detach the cable ground wire at the drive board.
5. Pull the cable up through the left upright to remove it.
6. Install a new cable following steps 1-5 in reverse order.
Field Functional Test
To verify that the treadmill is operating properly, perform Field Test No.
5. See “Field Test No. 5” on page D-6 for specific instructions.
Cumulative Use
The Cumulative Use feature lets you determine the amount of wear on the
belt and motor by displaying the total distance or total time of use for each
treadmill. This data can be useful for scheduling service.
♦
The cumulative time and distance are stored in the controller. Both values
are zero if a new controller is installed. Loading a factory default program
will reset the time and distance to zero.
Distance
To determine the total distance on each treadmill:
1. Press Power to turn on the treadmill controller.
2. Simultaneously press
Stop
and
Slower
.
3. Multiply the number that appears in the multifunction display by 10
to obtain the cumulative total in miles or hours.
4. Record the mileage and the date for your records.
5. Press
Clear
to reset the display for operation.
Time
To determine the total time of treadmill use:
1. Press
Power
to turn on the treadmill controller.
2. Simultaneously press
Stop
and
Faster
.
3. Multiply the number that appears in the center display by 10 to obtain
the total number of hours of operation.
4. Record the total time and the date for your records.
5. Press
Clear
to reset the display for operation.
