3-8 Troubleshooting
MedTrack CR60 Rehabilitation Treadmill Service Manual
*The type and the rate of bearing noise can help determine which bearing
is at fault. The number of knocks per minute varies with treadmill speed
because the roller speeds change as the belt speed changes.
**Use a mechanical stethoscope or a piece of hose about two feet long, to
isolate bearing problems. Hold one end of the hose near the suspected
bearing and the other end near your ear. Compare several bearings to
determine which is the faulty one.
Flow Charts
Use the flow charts on the following pages for step-by-step
troubleshooting.
Popping during grade
change.
Faulty elevation chain
alignment.
Adjust alignment of
sprockets.
Noise
Possible Cause
Action
Error Code Flow Chart
Page
EPHI and EPLO
“Bus Voltage Flow Chart” on page 3-9.
E201
“Grade Error Flow Chart” on page 3-10.
E203 (Drive Motor)
“Drive Motor Error Flow Chart” on page 3-11.
E204
“Communications Link” on page 3-12.
Grade Problems