Quikpoint Model 3, Operator'S Manual

Page: 3 / 12

Out of the Box Assembly
Step 1
Push the “Drive Shaft ”, into the “Wiper Coupling assembly”,
with the flat facing the Set Screw. Then tighten the
socket set screw with the Allen Wrench.
Drive Shaft
Flat
Wiper Coupling assembly
Step 2
Push the Drive Shaft -Auger Assembly into the
Tube and then through the “Bearing” as shown.
Push the Collar up against the Bearing.
Bearing
Collar
Tube
Drive Shaft -Auger Assembly
Handle
Nozzle Holder
Assembly
Cap Assembly
Wheel Holder
Assembly.
B.
Remove Nozzle Holder
Assembly from the Cap . A.
Slide Handle on to Tube.
C.
Slide Wheel Holder on
to the Cap assembly
D. Reinstall Nozzle
Holder assembly with
Allen Wrench
Step 3. A,B,C & D
Allen Wrench
Step 4
Key
Slide the Cap assembly on to the front of the Tube assembly. Line up the key in
the Cap with the slot in the Tube. Turn in the thumb screws.
Thumb Screw
Tube
Final Lightning Grouter Assembly.
Position the handle , for comfort ,
then tighten into place with the
Ring Clamp Tightener #34
Tightly chuck a drill to the Drive Shaft and use the appropriate Ring Clamp to attach the drill
to the Drill Arms. Use the Ring-Clamp tightener (#34)
Drill Arm
Ring Clamp
1
Step 5
Collar should
be against the
Bearing