19
User and installation guide Floor Temperature Controller
1. Principle of operation
The programmable temperature controller QuickTherm HF Room Thermostat Smart allows programming switching events (up to 9) and temperatures
according to personal needs. After installation the device automatically shows the time of day and the floor temperature. In AUTO mode, the heater will be
automatically activated according to programmed time and temperature. Program 1 is activated see 8. The floor temperature will be controlledaccording to
the temperature measured by the remote sensor.
The heater will be switched on when the temperature drops below the current set-point.
Actual Day
Actual Floor Temperature
Calling for Heat (Blinks if detached from power module or there is no mains power)
Helping text
Mode = AUTO
Time = 14:31
2. Installation
Caution!
The device may only be opened and installed according to the circuit diagram on the device or these instructions by a qualified electrician.
The existing safety regulations must be observed.
Appropriate installation measures must be taken to achieve the requirements of protection class II.
This independently mountable electronic device is de-signedfor controlling the temperature in dry and enclosed rooms only under normal
conditions. The device confirms to EN 60730, it works according operating principle 1C.
Summary of Contents for QuickTherm HF
Page 51: ...51...
