Quicksilver SmartCraft Systems, Reference Manual

Page: 92 / 110

2.0 Marine Diagnostics
90 Reference Manual
1- Mercury Marine
RESET BREAK-IN
Using the RESET BREAK-IN function, you can reprogram the ECMs
factory break-in oil mode.
IMPORTANT: In the event that a new powerhead is installed you
must reset the oiling routine.
Make sure that the SELECT FUNCTION menu screen is displayed on
the DDT. Press the 4 key.
Select Function:
1-OIL PUMP PRIME
2-CYLINDER MISFIRE
3-OUTPUT LOAD TEST
4-RESET BREAK-IN
↓
The RESET BREAK-IN OIL screen will appear. Press 1 key.
RESET BREAK-IN OIL:
PRESS 1 TO START
PRESS 2 TO CANCEL
PLEASE WAIT
RESET IN PROGRESS . . .
THIS MAY TAKE A FEW
MINUTES TO COMPLETE.
RESET BREAK-IN OIL
WILL PRIME THE OIL
PUMP AND CLEAR ALL
HISTORIES. 1=YES 2=NO
BREAK-IN OILING HAS
BEEN REACTIVATED,
PROGRAM SUCCESSFUL.
PRESS MODE TO EXIT.
Press the1 key.
Press the1 key.
Press the1 key.
NOTE: The reset mode will clear all fault and run history counters,
followed by a complete oil pump prime cycle.
Available
Press
To EXIT