Quicksilver 905WE — System & Component Overview and Operation
54
27.
L
-
Lounge Seating (optional)
If installed, an optional L
-
lounge seating configuration is available to provide extra seating in the
cockpit. The L
-
lounge seating consists of a fixed seat base with storage and a bridge seat located on
the port side of the cockpit.
A removable bridge seat between the aft cockpit seat and fixed seat base will create the L
-
lounge
seating. To install the seat, make sure that the cockpit seat is in the aft position. Next, set the base
between the fixed seat base and the aft cockpit seat and push down so that it engages with the rubber
stoppers. Now, attach the cushions to the seat bases and the backrest to the cockpit wall.
By lifting the lever again and moving the aft cockpit seat forward, you can rotate the backrest an
additional 60 degrees so that it lays flat. With the optional sun lounge conversion and L
-
lounge
conversion, the seat becomes a large area for sunbathing.
To return the backrest to it’s most upright position, simply lift the lever again and rotate the seat back
up.
26.
Cockpit Table (optional)
If equipped, a fiberglass cockpit table is available for entertaining. Included are two removable table
legs, which when not in use, are stored in the aft cockpit seat. To install the table, first remove the
plastic covers located in the table base plates. Next, push and lock the table legs into the base plates.
Finally, place the table onto the table legs. When not in use, the table can be placed in a convenient
bag and stored in the bilge.
Do NOT run the boat while the aft cockpit seat is laying flat.
Quicksilver® recommends that when the engine is running,
the seat back is in it’s most upright position.
Before reclining the backrest so that it lays flat, you must
move the cockpit seat forward. Failure to do so will cause
damage to the engine cowl and / or seat backrest.
Make sure the seat is locked in position before using.
Failure to do could lead to injury.
Cockpit Table
Table bases
Table legs
Table
Summary of Contents for 905WE
