Quicksilver 905WE, Owner'S Manual

Page: 55 / 87

43
Quicksilver 905WE — System & Component Overview and Operation
Refer to the manufacturer’s manual for complete instructions and warranty.
Diesel Heat
Exhaust gas is HOT. Ensure that there is nothing that is
susceptible to heat damage (i.e. ropes, fenders, other
boats) within 200mm of the exhaust outlet.
19. Air Conditioning (optional)
Single Air Conditioning Unit
The reverse cycle air conditioner system consists of a 12,000 BTU self contained air conditioning unit,
a seawater pickup, strainer, water pump, and control unit. The air conditioning unit, located on the
port side of the salon, can be easily accessed by removing a panel located in the aft salon bench seat.
Care should be taken to not stow items around the unit that may block the return air grill or damage
the refrigerant gas lines to the compressor.
Single Unit Operation
Prior to starting the air conditioner make sure that the water pickup seacock, located in the port side
of the bilge and accessed through the forward cockpit floor access hatch, is OPENED. The air
conditioner is controlled by a keypad located on the port side of the salon. The panel allows for either
automatic control of a preset temperature, or it allows you to vary the blower speed and temperature
manually. When the air conditioner unit is turned on, seawater is pumped into the system through the
seacock and strainer. The water passes through the compressor cooling the condensing coils, then
flows overboard to a thru hull drain. Any condensation on the air conditioner unit will collect in the air
conditioner pan and drain overboard.
There are three air ducts located throughout the boat. In the forward berth, there is an adjustable air
10L diesel tank
Fuel line
Diesel heater
Hot air ducts
Forward berth vent
Aft berth vent
Salon vent
Cold air ducts
Cabin return air vent
Exterior return air vents
Exhaust outlet
Control pad